Helping you build projects without a big shop using Japanese hand tools and power tools
To give the “workshed” a touch of class, we’re installing shiplap in the soffit area. There’s a quick discussion on if venting is needed or no, an explanation of the approach I took and a way to blend in the custom cuts necessary on the sides so they aren’t noticeable. Pricing of this part and Read More …
We’re going to finish up the upper sections of the side walls, and you’ll see how we’re going to adjust for the thickness of the rigid insulation that will go on the exterior of the walls. Read More …
Now that the walls are rigid from the structural sheathing we’re going to tackle the framing the roof. We’re going to use 2×8 lumber to make the roof frame. You’ll see how a speed square and hand saw is your best friend when it comes to cutting the birds-mouths for the rafters. Those 14 foot Read More …
In the previous articles we built the foundation, framed the floor and put flooring on the frame. Now we’ll frame up the walls, raise the them and lock everything in place with some top plates. There is a lot involved but we’ll take it one step at a time, and you’ll see that framing up Read More …
After you have the floor frame built, it’s time to move on to putting some flooring on. We’ll look at the small difference between using tongue and groove and regular panels. After that we’ll go over basic installation procedures. Below is the video on how we installed the flooring on our frame. I ran into a Read More …